COATS 6200HS Truck Wheel Balancer - Manual (Page 19)

Operation Guide
13
WEIGHT MODES
The COATS balancer features one Normal (clip-on) and
four Custom (Alu/Mag) Modes for combinations of clip-
on and stick-on weight s. A static balancing mode is
also included.
As the Mode Select Button on the control panel is
pressed, the Weight Location LED Indicators on the
Display Panel indicate the desired weight location.
When placing the weights for any of the Alu/Mag
modes, observe the location dimensions shown
opposite. Note also that these dimensions differ for Car/
Light Truck (diameter set below 17") and Truck wheels.
The balancer is programmed for these dimensions,
other placement locations will require different weights.
Normal:
LED’s 1 and 5 light to indicate standard clip-
on weights on the inner and outer rim flanges.
Alu/Mag 1:
LED’s 1 and 4 light to indicate a standard
clip-on weight on the inner flange and a stick-on weight
on the outer bead seat of the rim.
Alu/Mag 2:
LED’s 2 and 4 light to indicate stick-on
weights on the inner and outer bead seat areas of the
rim.
Alu/Mag 3:
For this hidden weight method, LED ’s 1
and 3 light to indicate a standard clip-on weight on the
inner flange and a stick-on weight towards the center
area of the rim.
Alu/Mag 4:
For this hidden weight method, LED ’s 2
and 3 light to indicate a stick-on weight on the inner
bead seat area and a stick-on weight towards the center
area of the rim.
When using the Alu/Mag 3 or Alu/Mag 4 Modes, the
inner and outer weights
MUST
be placed the correct
distance apart longitudinally (dimension “D”). The
balancer is programmed for this distance when using
these Modes. If it is necessary to use weight placements
not catered for in the section, refer to the Special
Applications section of the manual.
1 2 3 4 5
A = 0.5”/1.25cm / B = 0.75”/2cm / C = 1.5”/4cm / D = 4.0”/10cm
Weight Location Dimensions for Car / Light Truck