chiliGREEN W251CZQ - Manual (Page 157)

Modules & Options
3G Module 7 - 31
7
Before installing the application, make sure that the 3G module is ON (installing
the driver with the module off will not allow the software to detect the module hard-
ware correctly). Use the Fn +
key combination (see Table 1 - 4, on page 1 - 13 )
to toggle power to the 3G module. When the 3G module is powered on, the indica-
tor
will briefly be displayed. Make sure you install the drivers in the order indi-
cated in Table 4 - 1, on page 4 - 3 . Note that exiting the application does NOT
turn off the 3G module.
• Wireless Manager - See “Wireless Manager Installation” on page 7 - 32 for
driver installation information and “Wireless Manager Application” on page 7
- 33 for instructions on using Wireless Manager.
• AirCard Watcher - See “Sierra Wireless AirCard Watcher Installation” on
page 7 - 54 for driver installation information and “AirCard Watcher Applica-
tion” on page 7 - 55 for instructions on using AirCard Watcher.

3G Modules &
System Wake Up
Note that the 3G modules
DO NOT support system
wake up on 3G modem
activity.

Important Notice - 3G & Bluetooth/Wireless LAN Modules
In order to comply with FCC regulations you should NOT operate the 3G module and the
Bluetooth/Wireless LAN modules at the same time as this may disrupt radio frequency, and
cause interference. When the 3G module is powered on, make sure that the Bluetooth/
Wireless LAN modules are powered off.