2N Helios IP Configuration Manual v2.8 - Manual (Page 92)

92
2N TELEKOMUNIKACE a.s., www.2n.cz
®
5.5.1 Network
As the intercom is connected to the LAN, make sure that its IP address 2N Helios IP
®
has been set correctly or obtained from the LAN DHCP server. Configure the IP address
and DHCP in the
subsection. Network
If you use the RADIUS server and 802.1x-based verification of connected equipment,
you can make the intercom use the EAP-MD5 or EAP-TLS authentication. Set this
function in the
tab. 802.1x
The tab helps you launch capture of incoming and outgoing packets on the Trace
intercom network interface. The file with captured packets can be downloaded for
Wireshark processing, e.g. (
www.wireshark.org).
List of Parameters
Network
Use DHCP server – enable automatic obtaining of the IP address from the LAN
DHCP server. If the DHCP server is unavailable or inaccessible in your LAN, use
the manual network settings.
Tip
To know the current IP address of your intercom, use the 2N Helios IP
®
, which can be freely downloaded from , or apply the Scanner www.2n.cz
steps described in the Installation Manual of the respective intercom: the
intercom communicates its IP address to you via a voice function.