2N Helios IP Configuration Manual v2.8 User Manual
Page 25
25
address as follows: ip_address[:
][:
]. The
and
port1
port2
port1
port2
parameters are optional and are used in case there is Network Address
Translation (NAT) between the PC and intercom and the addresses have to
comply with the router or another NAT-executing device. The port1 (default
value: 8003) parameter defines the destination port for the UDP messages sent
to
. The port2 (default value: 80) parameter defines the
2N Helios IP Eye
®
destination port for the
– intercom HTTP communication.
2N Helios IP Eye
®
Parallel call to following number – enable group calling, i.e. calling to more
phone numbers at the same time. You can call the first two numbers, the last
two numbers, or all of the three user numbers in parallel. Answering one call
automatically terminates the other calls.
User deputy – select a user to which the user calls will be routed in the event of
inaccessibility. Enter Phone Book position number or use search button. The
deputy setting is applied when the user fails to answer the call to any of its
phone numbers within the predefined timeout, or if the user numbers are
inaccessible for other reasons (time profiles, user deactivation).
Each intercom user can be assigned its activation/deactivation code for call routing
purposes. If a user is deactivated, calls are routed not to its phone numbers but to the
predefined user deputy at inaccessibility.
User activation code – set a private user activation code: up to 16 characters
including digits 0-9 only. If the user activation code is the only code defined or
the activation and deactivation codes are identical, the activation code is used
both for user activation and deactivation.
User deactivation code – set a private user deactivation code: up to 16
characters including digits 0-9 only.
User current state – select the current state of the user.
Note
The 'Helios IP Eye Address' function is available in selected 2N Helios
®
models only (refer to the model and licence overview).
IP
Note
The User Deputy function is available in selected
2N Helios IP
®
models
).
only (refer to the model and licence overview