2N Helios IP Configuration Manual v2.8 - Manual (Page 103)

103
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2N Helios IP Vario
®
with MAC address 00-87-12-AA-00-11 downloads the following
files from the TFTP server:
hipv-firmware.bin
hipv-common.xml
hipv-00-87-12-aa-00-11.xml
Configuration
Use the tab to set automatic configuration download from the server Configuration
defined by you. The intercom periodically downloads a file from the server and gets
reconfigured without getting restarted.
List of Parameters
Firmware update enabled – enable automatic firmware/configuration updating
from the TFTP/HTTP server.
Address retrieval mode – select whether the TFTP/HTTP server address shall
be entered manually or a value retrieved automatically from the DHCP server
using Option 66 shall be used.
Server address – enter the TFTP (tftp://ip_address), HTTP (
) http://ip_address
or HTTPS ( ) server address manually. https://ip_address
DHCP (Option 66/150) address – check the server address retrieved via the
DHCP Option 66 or 150.
File path – set the firmware/configuration filename directory or prefix on the
server. The intercom expects the XhipY_firmware.bin, XhipY-common.xml and
XhipY-MACADDR.xml files, where X is the prefix specified herein and Y specifies
the intercom model.
Poznámka
A few seconds' interruption of the display function occurs in the
display-equipped
models during reconfiguration. 2N Helios IP Vario
®
Therefore, we recommend you to update when the intercom traffic is very
low (at night, e.g.).