2N Helios IP Configuration Manual v2.8 User Manual

Page 36

The table above includes a list of universal codes that help you activate switches from
the phone or intercom keypad. Up to 10 universal codes can be defined for each switch
(depending on the particular intercom model).

Code – enter a numeric code for the switch. The code must include 2 characters
at least but we recommend you to use four characters at least to make the code
accessible from the intercom numeric keypad. Codes 00 and 11 can't be entered
from numeric keypad. Code is confirmed with *.
Accessibility – block the switch activation code entering from the intercom
numeric keypad or your phone.
Time profile – assign a time profile to the switch code to control its validity.

Activation by call – enable switch activation by an incoming or outgoing call,
for example. During an outgoing call the switch is activated after SIP message
180 Ringing is received. The called party confirms ringing by this message. The
switch is active during the whole call in the bistable mode, and activated by the
call beginning and deactivated after the predefined switch-on duration in the
monostable mode.

Note

– be sure to set the internal power supply and

Helios IP Vario

switching relay on the configuration connector.
2N

– the security relay is connected to the DOOR +

Helios IP Force

and - terminals.

Note

The extended switch activation is available with the Gold or Enhanced
Integration licence only.