Network parameter setting, Serial console access – 2N VoiceBlue Enterprise - User Manual User Manual
Page 49
Administration 3-25
3.3. Network Parameter Setting
Before starting to use the 2N VoiceBlue Enterprise gateway for
making calls, remember to set its network parameters. You can do
this in two ways. If the gateway has a factory setup or you know
its IP address, you can connect a PC to it using a crossed Ethernet
cable and select the respective parameters using the web browser.
Or, in other cases, you will definitely appreciate access via the
serial port using a character terminal, e.g. the HyperTerminal.
Serial Console Access
Connect the gateway to your PC as described in Subsection 2.8.
The main menu gets displayed on the terminal. Select the
Configuration item and then Network. The menu shown in fig. 12
will get displayed.
VoiceBlue Enterprise Main Menu
Option Value Description
1 - Address [ 10.0.0.1 ] - Internet
address
2 - Network Mask [ 255.0.0.0 ] - Internet
subnet mask
3 - Gateway [ 0.0.0.0 ] - Internet
default gateway
4 - Routing [ menu ] - IP routing
table configuration
5 - Dns1 [ 0.0.0.0 ] - DNS server 1
6 - Dns2 [ 0.0.0.0 ] - DNS server 2
7 - Host name [ "voiceblue" ] - Host name
8 - Domain [ "" ] - Domain name
9 - Location [ "" ] - Location
01 - Contact [ "" ] - Contact
02 - Dhcp [ off ] - Use DHCP on
03 - Class [ "" ] - DHCP class
Enter an option number,
>
Fig. 12 – Network Parameter Configuration by Serial Console