2N VoiceBlue Enterprise - User Manual - Manual (Page 41)

Administration 3-17
idx=1 name="sip" lines=SIM:8942001103538068335
timeint=weekdays;weekend;workdays
desc=""
3.2.2.1.7 Command ‘sip’
Command sip allows you to set, modify and delete SIP lines.
There are following parameters to this command:
help - prints short help
list - prints a list of all SIP lines, REGISTER, CLIP and NAT are
listed only if enabled, password is never listed
ls - same as a previous command
add - adds SIP line to the list, there are other parameters needed,
none of them required (parameters can be written in an arbitrary
order).
server= - specifies SIP Server address
name= - specifies SIP Name
disp_name= - specifies Display name
listen_port= - specifies Listen port
user= - specifies User name, must be valid
VoiceBlue user name
passw= - specifies Password for user name
codecs= - specifies Codecs, valid values are g711alaw, g711ulaw,
g729, separated by semicolon, at most three codecs are allowed
add_to_req= - specifies Add Phone context to
REGISTER requset
reg_exp= - specifies Register expiration time in seconds
REGISTER|NO_REGISTER - enables or disables SIP registration
CLIP|NO_CLIP - enables or disables CLIP
NAT|NO_NAT - enables or disables NAT
nat_b= - specifies NAT port begin
nat_r= - specifies NAT port range