2N VoiceBlue Enterprise - User Manual - Manual (Page 17)

Installation 2-3
2.2. Brief Installation Guide
•
Proper mounting – 2N VoiceBlue Enterprise is designed for
suspension on a vertical surface. Fit the holder included in the
delivery on a wall and hang the gateway on it. For details on
the prescribed working position and other recommendations
refer to Subsection 2.3.
•
Cable connection – connect the gateway using a patch-cable
to the LAN (Local Area Network). For details on proper wiring
refer to Subsection 2.4.
•
Antenna connection – connect an internal antenna or an
external antenna cable to the SMA antenna connector. Place
the external antenna on a place with a good GSM signal (refer
to Subsection 2.5).
•
Gateway power supply – the delivery includes a mains
adapter. Plug in the adapter connector into the gateway and the
power adapter into a mains socket (
≈
230V/50Hz). The gateway
turns on immediately (see Subsection 2.6).
•
SIM card insertion – SIM cards are inserted in holders on the
gateway top. To slide the drawer out of the gateway press the
yellow button on the drawer with a suitable tool (pin, pencil,
...), see Subsection 2.7.
•
PC connection and initial configuration – a web browser is
used for gateway configuration in normal operation. If you
have not defined the IP address for the gateway, use the serial
cable included in the delivery (refer to Subsection 2.8) for
initial configuration of the basic parameters (see Section 3).
•
Setting and monitoring – Having set the basic network
parameters (IP address, etc.), you can configure the VoIP
gateway using a standard web browser. Configuration options
and essential procedures shall be discussed in detail in
respective sections.