2N VoiceBlue Enterprise - User Manual - Manual (Page 36)

3-12 2N
®
VoiceBlue Enterprise
list [] - prints a list of all LCRs or lists only LCR with
specified
ls [] - same as a previous command
add - adds LCR to the list, there are other parameters needed, some
of them required (parameters can be written in an arbitrary order).
destination= - specifies Destination name,
required
prefix=prefix1,prefix2,...,prefix8 - specifies Prefixes, can be
regular expressions,
separated by comma, maximal eight prefixes allowed, not required
enabled|disabled - enables or disables added LCR, required
route= - specifies route for LCR, route must be
valid, required
priority=pr_type_1,pr_type_2,pr_type_3,pr_type_4 - specifies
Priority types,
valid values are first_free, cycles and free_minutes, value default
will be used for not specified priority type number (default value is
not listed), at most four Priority types are allowed, separated by
comma, not required
desc= - specifies Description, not required
replace idx= - replaces LCR with an specified. If LCR
list is empty, this
command is not allowed, same parameters as for previous
command are possible, if some parameter is omitted when
replacing, original value will be used
del - deletes LCR with an specified
shift from= to= - shifts LCR from the position
to the
position , this usually takes some time
enable - enables LCR with an specified
disable - disables LCR with an specified
Example: There are two LCRs in a list. User decides to insert new
disabled LCR between them with Destination name value ”lcr3”,