Eppendorf S41i Incubator Shaker - Manual (Page 27)

27
S41i CO2 Incubator Shaker — Operating manual
 Press the High Alarm line and use the popup keypad to set the speed at which an alarm will
alert you to the rpm rising too high.
 Press the Low Alarm line and use the popup keypad to set the speed at which an alarm will
alert you to the rpm level falling too low.
 Press the Setpoint line and use the popup keypad to set the desired shaking speed.
 Press the Set Hours line to set the number of hours of shaking you wish to program, using the
popup keypad.
 Do the same to Set Minutes.
 After you program the Hours and Minutes of the run time and then press OK the button to
return to the STATUS screen.
 Now there will be a STOPWATCH icon next to RPM, to indicate that the countdown of Run
Time has been enabled:
5.4.6 % RH
If your New Brunswick S41i is not equipped with an optional humidity sensor, the STATUS screen
will not display % RH.
If your New Brunswick S41i is equipped with an optional humidity sensor, the STATUS screen will
show % RH (relative humidity) at the bottom of the screen:
This is a current reading; you cannot program any setpoints or alarms.
Hint!
O
2
option not available.
5
Op
er
at
ion