Eppendorf S41i Incubator Shaker - Manual (Page 14)

S41i CO2 Incubator Shaker — Operating manual
14
2. Snap the side shield in place, then slide it toward the back of the incubator/shaker until the
bracket is flush against the front face.
3. Fasten the bracket to the incubator/shaker with one M4 screw:
Abb. 5: Side foot shield bracket
Fig. 5: Side foot shield bracket
4. Repeat Steps 1 through 3 for the left side foot shield.
5. Push fit the remaining foot shield onto the bottom front of the incubator/shaker. Be sure to
align its pins with the holes on the incubator/shaker and on the mounting brackets of the side
foot shields.
Abb. 6: Front foot shield installation
Fig. 6: Front foot shield installation
4.6 Platform assemblies
A platform, which is required for operation, is a separate item, not included with the shaker
assembly. The S41i platform, measuring 612 × 356 mm (24 × 14 in), will accept a wide range of
clamps for flasks, test tubes, etc.
4.7 Installation of platform
The incubator/shaker is shipped with four Allen head platform screws installed in the four bearing
housing uprights, as shown below:
1 M4 screw inserted here to fasten the side foot shield bracket to the incubator/shaker
Hint!
Prior to use, a platform must be installed on the incubator/shaker.
4
Installation