Snorkel TB60 2001 - Manual (Page 64)

10. DAILY INSPECTION & MAINTENANCE
10 - 12 P/N 0082168
26. Platform work lights (option)
While the engine is running, momentarily turn
each work light on (use the switch on the back of
each light) to see that they both work.
27. Flashing light (option)
Visually check to see that the light flashes at
approximately one flash per second when the
engine is running.
28. Driving lights (option)
While the engine is running, momentarily turn the
driving lights on to see that they work.
29. Slide pads
2 1
With the engine running, use the ground-control
panel to raise and extend the booms about 10
feet (three meters). Visually inspect to see that
all 12 slide pads (1) are in place.
Look at the surfaces (2) that slide on each slide
pad — the paint should still be in place and there
should not be any signs of bare metal gouging.
Completely retract the booms then turn the
engine OFF at the ground-control panel
MASTER switch.
30. Wire ropes
Check the condition of the wire ropes near both
ends of the base-boom. The wire ropes should
not have any broken strands or be distorted in
any way.