Snorkel TB60 2001 - Manual (Page 39)

7. OPERATION
7 - 5 P/N 0082168
C A U TIO N
If the engine fails to start (at the next step) in 20
seconds, turn the ANTI-RESTART MASTER
SWITCH to OFF and wait 60 seconds before
turning the switch to START again.
2. Turn the ANTI-RESTART MASTER SWITCH
(2) to START and hold it there until the engine
starts (or for a maximum of 20 seconds) then
release the switch to ON.
NOTE: Do not step on the foot switch while
you are trying to start the engine.
The engine should now be running.
„
MOVING THE PLATFORM
The engine should already be running (as
described earlier in this chapter) before you start
this section.
D A N G E R
Be certain that the space into which you are
about to move the platform, boom, turntable,
and chassis is free of obstructions. Always
look in the direction of movement.
Be careful when operating a TB 60 within 132
feet (40 meters) of an overhead electric-
power line.
D A N G E R
If you operate from the platform-control box
be sure that the lanyard of your fall restraint
is attached to one of the lanyard anchor
points on the platform mount. Also, be sure
the gate is closed behind you.
Each of the ways the platform can move is
shown in the following two-page spread. The
photos show the switches to push to move the
platform. The switch call-out numbers (on the
left-hand page) correspond to the illustration
numbers on the right-hand page.
NOTE: At the end of each work day the TB 60
should be returned to the STOWED
POSITION as described under STOWING in
the “STOWING & TRANSPORTING” chapter.