Snorkel TB60 2001 - Manual (Page 36)

7. OPERATION
7 - 2 P/N 0082168
3. Set the SELECTOR SWITCH (3) to GROUND.
4. Flip the red cover (8) up then set the
EMERGENCY STOP toggle switch (4) to UP
FOR RUN.
5. Set the ENGINE SPEED switch (5) to SLOW.
6. Set the BOOM SPEED control (6) as shown.
7. (OPTION - DUAL FUEL) For machines set up
to run both gasoline and LP gas: Set the FUEL
switch (7) to GASOLINE or L.P.-GAS depending
on which you want to use. If you select L.P.-
GAS, open the valve on top the LP gas tank.
Y
Starting (from the ground)
Do not attempt to start a TB 60 until the actions
in the previous part of this section (STARTING
FROM THE GROUND-CONTROL PANEL) have
been completed.
1. Insert the key into the MASTER switch (1).
2. Turn the key (2) to ON and pause there a few
seconds while a siren sounds to alert others that
the TB 60 is about to start.
NOTE: If you pause 30 seconds or more an
automatic protection feature will prevent the
TB 60 from starting. If that happens, turn the
key (2) to OFF and try again.