Snorkel TB60 2001 - Manual (Page 37)

7. OPERATION
7 - 3 P/N 0082168
C A U TIO N
If the engine fails to start (at the next step) in 20
seconds, turn the key to OFF and wait 60
seconds before turning the key to START again.
3. Turn the key (3) to START and hold it there
until the engine starts (or for a maximum of 20
seconds) then release the key to ON.
The engine should now be running.
NOTE: If you want to move the platform from
the ground-control station, skip the next
section and go to MOVING THE PLATFORM.
„
STARTING FROM THE PLATFORM-
CONTROL BOX
Before you begin to operate the TB 60 a qualified
operator must perform the “DAILY INSPECTION
& MAINTENANCE” described in the chapter by
that name in this manual.
Y
Pre-start Conditions
After the DAILY INSPECTION & MAINTENANCE
has been performed, put the TB 60 into its pre-
start conditions. Pre-start conditions for operation
from the platform-control box are:
1. Set the BATTERY switch (1) to ON (close the
battery-compartment door).
2. Check the circuit breakers (2) to see that none
has popped out (close the engine-compartment
door).