Snorkel TB60 2001 - Manual (Page 53)

10. DAILY INSPECTION & MAINTENANCE
10 - 1 P/N 0082168
At the start of each work day (or 8 hour shift) a
TB 60 qualified operator must perform the DAILY
INSPECTION AND MAINTENANCE listed in the
table below.
The purpose of the daily inspection and
maintenance is to keep the TB 60 in proper
working condition and to detect signs of
malfunction at the earliest possible time.
D A N G E R
Do not operate a TB 60 that is known to be
damaged or malfunctioning. Defective parts
or equipment malfunctions jeopardize the
safety of the operator and other personnel,
and can cause damage to the machine.
DAILY INSPECTION AND MAINTENANCE
(Set the MASTER switch to OFF before you begin this inspection.)
ITEM SERVICE REQUIRED
1. Engine fuel level Check fuel gauge (full)
2. Fuel tank cap Visually inspect (installation)
3. Engine oil Check oil level (between dipstick lines)
4. Fuel leaks Visually inspect (hoses, connections, etc.)
5. Engine coolant Check fluid level and radiator hoses
6. Wiring harnesses Visually inspect (installation, condition)
7. Battery terminals Visually inspect (corrosion)
8. Battery fluid level Check fluid level (in contact with filler neck)
9. Hydraulic oil Check oil level (between lines on gauge)
10. Hydraulic oil leaks Visually inspect (hoses, tubes)
11. Tires Visually inspect (condition)
12. Bolts and fasteners Visually inspect (looseness)
13. Structural damage & welds Visually inspect (weld cracks, dents)
14. Guardrails Visually check condition
15. Platform gravity gate Visually inspect (operation)
16. Self-closing gate (option) Actuate and visually check condition
17. Lanyard anchor points Visually check condition
18. Emergency power motor/pump Check operation (causes correct motion)
19. Air filter Check condition (gauge)
20. Charging system Visually inspect (gauge)
21. Ground-control panel switches and alarms Actuate and visually check for operation
22. Level sensor Actuate and listen for alarm to sound
23. Platform-control box switches and alarms Actuate and visually check for operation
24. GFCI (ground fault circuit interrupt) (option) Actuate and visually check for operation
25. Placards and decals Visually inspect (installation, condition)
26. Platform work lights (option) Turn them on to see that they work
27. Flashing lights (option) Turn it on to see that it works
28. Driving light (option) Turn them on to see that they work
29. Slide pads Visually inspect (boom-wear marks)
30. Wire ropes Visually inspect (even tension)
10. DAILY INSPECTION & MAINTENANCE