Apple Power Macintosh 4400 - Manual (Page 23)

Putting your computer to sleep
Your Power Macintosh is preset to put itself to sleep after 30 minutes of
inactivity. When your computer goes to sleep, the screen enters a low-power
mode in which it dims and the hard disk stops spinning but remains ready to
start back up quickly. (To prevent your computer from overheating, the fan
continues to spin.) If the computer goes to sleep while you have unsaved
information on screen, you do not lose any of the information.
To put your computer to sleep right away, choose the Sleep command from
the Special menu, or press the Power key on the keyboard to bring up the
Shutdown dialog box pictured below.
To set sleep options, use the Energy Saver control panel, available under
Control Panels in the Apple (K) menu.
23 Getting Started
Click here to put your computer to sleep now.
Click here to set up automatic
startup and shutdown.
Drag the slider to set the time
to wait before sleeping.
Click here to have
the computer shut
down instead of
going to sleep.
Click here to set
separate timing for
monitor sleep.
Click here to set
separate timing for
hard disk sleep.