Apple Power Macintosh 4400 - Manual (Page 170)

Note: After you have finished these installation instructions and turned on
your computer, you may need to install software for your communication card.
If you installed an Ethernet card, you may also need to change the network
connection in the AppleTalk control panel. See your network administrator,
the manual that came with the card, and refer to Chapter 5, “Connecting Your
Computer to a Network,” earlier in this manual for more information.
10 If you have DIMMs to install, follow the instructions in the next section. If you are
finished installing items, proceed to “Closing the Computer.”
Installing memory, video, or cache DIMMs
The DRAM sockets are located behind the card that supports the PCI cards
in your computer. It may be difficult to maneuver the DRAM DIMMs in this
space, so Apple recommends that you have an Apple-authorized service
provider install your DRAM DIMMs. Refer to the section “DRAM
Configurations” earlier in this chapter for the types and sizes of DIMMs that
can be installed in your computer.
WARNING Although instructions for installing DIMMs are provided in
this manual, Apple Computer strongly recommends that you have an
Apple-certified technician install them. Consult the service and support
information that came with your computer for instructions on how to
contact an Apple-authorized service provider or Apple for service. If
you install additional DIMMs yourself, you risk damaging your
equipment, and this damage is not covered by the limited warranty on
your computer. See an Apple-authorized dealer or service provider for
additional information about this or any other warranty question.
170 Appendix B