Apple Xserve (Slot Load) - Manual (Page 78)

78 Chapter 5
3 Open the server to its full length.
See “Opening and Closing the Server” on page 61 for details.
You can also remove the server from the rack (leaving the cover in place) and install the
battery with the server on a sturdy flat surface.
4 Locate the battery holder near the back of the server.
5 Remove the battery from its holder, noting the orientation of the battery’s positive end.
(A plus sign is marked on the holder.)
6 Insert the new battery in the holder, making sure the battery’s positive end aligns with the
positive symbol on the holder.
7 Close the server and tighten the thumbscrews to secure it.
8 Reconnect all cords and cables.
Remove the battery by pulling it up and out of
its holder. You may need to spread these two tabs
slightly apart to release the battery. Spread the
tabs gently so they don’t break. Positive and
negative symbols are molded inside the holder
to help you orient the battery correctly.
Important Batteries contain chemicals, some of which may be harmful to the environment.
Please dispose of used batteries according to your local environmental laws and guidelines.