Apple Xserve (Slot Load) - Manual (Page 38)

38 Chapter 3
6 Connect the cables to the back panel of the server.
7 Connect the power cord and its retaining clip to the back of the server.
If more than one power cord came with your server, use the appropriate cord for the
electrical service available at your location.
Note: You may need to bend the cord near its plug to fit it into the server. Bending the cord
will not affect its operation.
8 Connect the other end of the cables to the appropriate devices.
9 Close the server and tighten the thumbscrews to secure it in the rack.
USB ports (2)
FireWire 800 ports (2) Power socket Gigabit Ethernet port
VGA monitor port Serial console port
Attach the power cord
retainer clip to the two
loops on the back of
the server. Snap the
cord into the clip so that
it cradles the cord.