Apple Xserve (Slot Load) - Manual (Page 32)

32 Chapter 3
3 At the back of the server, position the small bracket inside the server’s cover so that the head
of one rivet is facing the side of the cover.
Note: Start on the left side of the server (when facing the back). This makes installing the
cable-management arm more efficient.
4 Push the rivet head through the hole that’s near the back on the side of the cover.
The head of the rivet protrudes through the cover.
5 Position the long, U-shaped brace on the outside of the server’s cover, so that the curved end
is near the protruding rivet. The indented lip at the curved end of the brace should face the
rivet head.
6 Slide the lip at the end of the brace over both rivets on the small bracket and continue to
slide the brace forward a few inches.
Make sure the brace is on the outside of the cover and that both rivets are captured in the
center opening of the brace.
Install the brackets on
the inside of the top cover.
The forward rivet on each bracket
must pass through the hole in the cover.
Each bracket must be
installed with the rivets
oriented high on the bracket.
Slide the brace
toward the front of the cover.
Make sure that both rivets
on the bracket have engaged
the slot in the brace.