Apple Xserve (Slot Load) - Manual (Page 40)

40 Chapter 3
4 Position the cable-management arm so that the hinged section is on the inside of the left
brace, about 2 inches behind the server’s back panel.
5 Hold the arm in place and put the clamp you detached on the opposite side of the arm, so
that the screw hole in the center shows through the open part of the brace.
6 Insert the screw into its hole and tighten it so that the arm is fastened to the brace.
7 Verify that the arm’s position is correct by moving the arm inward so that it swings under the
cover of the server.
If the arm hits the cover or is not level as you move it, you need to adjust its position by
unscrewing one or both mounting screws and moving the arm up or down slightly until it is
level and moves smoothly under the server’s cover.
8 Connect the cables to the back panel of the server.
See “Connect Cables Directly to the Server” on page 50 for more information about
connecting cables.
Mount the cable-management arm as close to the back of the server as possible.
Rotate the mounting plate on the arm so that it lies against the inside of
the U-shaped bracket. The U-shaped bracket should be
sandwiched between the arm and the small clamp.
Secure the clamp with the screw that held
it stored on the arm.
Clamp Screw Cable-management arm U-shaped bracket
USB ports (2)
FireWire 800 ports (2) Power socket Gigabit Ethernet port
VGA monitor port Serial console port