Defi ADVANCE ZD User Manual

Page 9

7 Installation

7 -1. Confirmation of contents.

Confirm the contents. ⇒ Refer to 5 Parts list.

7 -2. Installation of ADVANCE Control unit and sensors

Install ADVANCE Control unit, sensors, and sensor wires by referring to the manuals.
⇒ Refer to manuals of ADVANCE Control unit, gauges, and sensor sets

7 -3. Wiring of speed and tachometer signal wire

1. Disconnect the negative(-) battery terminal.
2. Connect the green wire(SP) to SP signal of ECU.
3. Connect the blue wire(TA) to TA signal of ECU. If the tachometer signal wire

of ADVANCE series is already wired, connect only the green wire. (Do not
use the speed and tachometer signal wire included in this product.)

　⇒ Refer to how to solder and how to use the solderless connectors.
4. Connect the speed and tachometer signal wire to ADVANCE Control unit. (In

case the wire is already connected, skip this step.)

5. Connect the negative(-) battery terminal.
6. Set the speed pulse, number of cylinders, and tachometer response after all

the installation and wiring are done by referring operation section.

■ Caution for wiring of speed and tachometer signal wires

Caution

If there is an unconnected wire, be sure to insulate it.

7 -4. Installation of ZD and wiring of meter wire

1. The bolt holder and the hexagon head bolt

are inserted into the slit of brace. And the
knob is temporarily fastened.

2. Insert convex part of the mounting bracket

over the legs of the brace. And Attach the
mounting bracket to the brace with the
bolt, nut and washer included in the kit as
shown in the figure 1.

3. Cut the buffer into 30x85mm (2 pieces) and

attach them to the backside of ZD (2 places)
as shown in figure 2.

4. Connect the meter wire to the connector

on the backside of ZD.

5. Insert the bolt holder of brace into the

groove of ZD and then fasten the knob as
shown in figure 3. If it is too tight-fitting to
insert, unfasten the knob once.

6. Adjust the angle and location to attach.

The mounting bracket is bendable to fit on
the place to attach.

7. Attach double sided tape on backside of

the mounting bracket (4 places) as shown
in figure 4. Fix ZD on the place where you
intend to attach it.

8. Confirm the knob and bolts are fastened

firmly and ZD is fixed firmly.

9. Carry out the final confirmation according

to the manual of ADVANCE Control unit.

　⇒ Refer to manual of ADVANCE Control unit.

【Fig.1】Fix brace on bracket

【Fig.3】Insert brace to ZD

【Fig.4】Attach tape on bracket

Screw holes(Φ4.4mm)