Defi ADVANCE ZD User Manual
Page 13
8 -2-7. Warm-up setting [WARM UP MODE]
Choose [WARM UP MODE] by pressing
M
or
R
button, and then
press
L
button. Select [WATER
TEMP] or [OIL TEMP] by pressing
M
or
R
button, and then press
L
button.
If [WATER TEMP] or [OIL TEMP] is selected, set
the temperature which warming-up is done by
pressing
M
or
R
button. If
M
or
R
button is pressed
long, the setting value changes quickly. Then
press
L
button to set.
8 -2-8. Clock setting [CLOCK]
Choose [CLOCK] by pressing
M
or
R
button, and then press
L
button. Set the watch(hour)
by pressing
M
or
R
button,
and then press
L
button.
Set the watch(minute) by pressing
M
or
R
button, and then press
L
button.
If you connect more than one ZD
※ If you additionally connect ZD which was connected to other vehicle to
your vehicle, you need to set the display number first.
⇒ Refer to
8
-3-8. Display number setting.
If you connect more than one ZD, one of the ZDs is set as an ACTIVE display.
■ The role of ACTIVE display
ACTIVE display controls the brightness of all the connected displays (and
gauges) by sensing the outside brightness with the dim sensor if the AUTO
dimmer is on. SYSTEM SETUP menu is displayed only on the ACTIVE display.
■ How to change the ACTIVE ZD
CU OPR
(slide switch position：
L
)
1. Set the slide switch to
L
.
2. The ACTIVE ZD is changed each time
M
or
R
button is
pressed and [ACTIVE] is displayed in multi-display zone (Zone A5).
※ [ACTIVE] is not displayed when only one ZD is connected to the ADVANCE system.
⇒ Refer to 8 -4. Display item change
as for multi-display zone.
The settings of the following system setup menu can be changed in each ZD.
8 -2-1. Units setting 8 -2-6. Special display setting/ 8 -2-7. Warm-up setting
Change the ACTIVE ZD first to change the settings of 8 -2-1, 8 -2-6, and 8 -2-7
if several ZDs are connected to the ADVANCE system.
73
74
Non-ACTIVE display
ACTIVE display