Defi ADVANCE ZD User Manual
Page 25
8 -9. Sequential indicator
8 LEDs (red) light up or blink depending on the engine revolutions. The light-
ing pattern can be selected from [SINGLE] and [DUAL]. The lighting pattern
and step is set in display setup mode.
⇒ Refer to 8 -3. Display setup mode (S2).
■ Engine revolutions that LED is lighted up
[SINGLE] ＝ (warning setting value of engine revolutions) － (lighting step) × 8
[DUAL] ＝ (warning setting value of engine revolutions) － (lighting step) × 4
■ Engine revolutions that all LEDs are lighted up
[SINGLE] ＝ [DUAL] ＝ (warning setting value of engine revolutions) － (lighting step)
■ Engine revolutions that all LEDs blink
At higher than or equal to warning setting value of engine revolutions
If the dimmer setting is AUTO, the brightness of LEDs is decreased one level
automatically depending on the outside brightness. If the dimmer setting is
MANUAL, the brightness of LEDs is decreased one level being interlocked with
the illumination switch of the vehicle.
[SINGLE]
LEDs (from left)
1
2
3
4
5
6
7
8
Blink
Lighting
revolutions(RPM)
7200 7300 7400 7500 7600 7700 7800 7900 8000
[DUAL]
LED (from left)
1
2
3
4
5
6
7
8
Blink
Lighting
revolutions(RPM)
7600 7700 7800 7900 7900 7800 7700 7600 8000
※ If ADVANCE BF Φ 80 Tachometer is connected, the higher setting value of
warning would be the basing point for lighting and blinking of LED.
8 -10. Alarm function
If the alarm is set, buzzer sounds and sequential indicator blinks at the setting
time. Buzzer sounds for a minute. Sequential indicator (all the LEDs) blinks at
the same time.
※ The alarm does not function unless the ignition is on at the set time.
ZD OPR
Press
L
SELECT
or
R
SET
button to stop the alarm during the alarm.
⇒ Refer to 8 -3-7. Alarm setting [ALARM] for how to set up.
※ The clock is semidiurnal. Alarm can be set within only 12 hours. This func-
tion alarms only one time after setting. The alarm needs to be set again
after using the function once.
97
98