Defi ADVANCE ZD User Manual

Page 15

8 -3-5. Oil pressure warning limit setting [OIL PRESS WARNING LIMIT]

The warning function of oil pressure is put out when engine revolutions are
under the set value. ※ This setting is reflected only to the ZD which is changed.
Choose [OIL PRESS WARNING LIMIT] by press-
ing

SET

button. Each time

SELECT

button is pressed, the value increases by
500RPM.
Setting range：0RPM 11000RPM

8 -3-6. Warning buzzer setting [DISPLAY WARNING BUZZER]

The warning buzzer can be turned on and off.
Buzzer does not sound in playback mode independently of buzzer setting even
while values exceed the warning settings. (Warning items are highlighted.)

Choose [DISPLAY WARNING BUZZER] by press-
ing

SET

button. Select [ON] or [OFF] by

pressing

SELECT

button.

※ The buzzer setting of ZD is not interlocked with that of ADVANCE Control

unit. Refer to manual of ADVANCE Control unit. We recommend for the fol-
lowing setting: ADVANCE Control unit buzzer –OFF, ZD buzzer - ON

※ Warning buzzer can be turned on and off, but bleep of operation cannot be

turned off.

8 -3-7. Alarm setting [ALARM]

Alarm can be activated at the set time.
(To activate the alarm, ignition key needs to be on at the set time.)

Choose [ALARM] by pressing

SET

but-

ton.
To set the alarm OFF, select [OFF] by pressing

SELECT

button and then press

SET

button.

To set the alarm ON, select [ON] by pressing

SELECT

button and then press

SET

button.

Set the watch(hour) by pressing

SELECT

button and then press

SET

button. If

SELECT

button is pressed long, the digit

changes quickly.

Set the watch(minute) by pressing

SELECT

button and then press

SET

button. If

SELECT

button is pressed long, the digit

changes quickly.

8 -3-8. Display number setting [DISPLAY NO.]

Choose [DISPLAY NO.] by pressing

SET

button. Select proper display number by
pressing

SELECT

button.

※ When one brand-new ZD is purchased at store and installed, the display

number is not necessary to be changed. When more than one brand-
new ZDs are connected or when you additionally connect ZD which was
connected to other vehicle to your vehicle, you need to set the display
number first. Set different numbers to each ZD. If ZDs that have the same
display number are connected, those ZDs do not function normally.

Turn the ignition key off once and turn on again if the display numbers are
changed.