Defi ADVANCE ZD User Manual

Page 19

8 -6-2-3. Warm-up display

Setting the water temperature or oil pressure in system setup mode runs
warm-up display. While the actual temperature is lower than the set value, the
name of item (oil press or water temp) blinks once a second.
Blinking stops when the actual temperature exceeds the setting value.

※ Special display is not performed independently of setting of special display

during warm-up display.

8 -6-2-4. Special display

A graphic animation is played after the speed signal keeps 0km/h(0MPH) for
more than 10 seconds by setting the special mode on.
Sensoring information, clock, and idling time are displayed during the special
display. Idling time is not counted when the vehicle engine is stopped even
when the ignition is on.

Special display is stopped when
　・speed signal is input
　・

SELECT

SET

button is pressed

　・the mode is changed with the switch unit of Control unit

※ Unless the speed signal is not input, even if special display is stopped the

idling time keeps being counted. And the cumulative idling time is dis-
played after the speed signal keeps 0km/h(0MPH) for more than 10 seconds
again.

Special display is not played during
　・warm-up
　・warning
　・short-circuit or wire disconnection
　・alarm
　・time attack mode
　・measuring time attack

8 -6-2-5. STREET

STREET display mode displays speed, odometer, and tripmeter all the time.

※ The speed, odometer, and tripmeter are just for reference. If there is a mar-

gin of error in speed pulses setting, the margin of error is accumulated not
only on the speed but also on the odometer and tripmeter.

■ Default display setting

× is displayed on the item zone that sensors are
not connected.

■ Zones which the display item can be changed

Zones that the display item can be changed are
A1and A2.

⇒ Refer to 8 -4. Display item change.

■ Reset of tripmeter

ZD OPR

The tripmeter can be reset by pressing

SET

button long during STREET

display mode.
※ The odometer cannot be reset.

8 -6-2-6. GAUGE1, GAUGE2

Display items can be changed in all the zones in GAUGE display modes. 2 lay-
outs can be set in GAUGE1 and GAUGE2. (Odometer and tripmeter cannot be
displayed.)

Clock

Water Temp

Speed

ODO

TRIP

Zone A1

Zone A2

Speed

ODO

TRIP