Defi ADVANCE ZD User Manual
Page 17
8 -5. Opening mode, Ending mode
When the ignition is turned on, ZD performs opening mode. When the igni-
tion is turned off, ZD performs ending mode and then the power supplies to
the unit and ZD are shut off.
Confirmation
Depending on vehicles, the ignition is not turned off immediately after the
key is turned off. In this case, ending mode doesn’t start until the ignition is
turned off.
■ Change of Opening mode/Ending mode
Opening and ending modes can be selected from A and B types by sliding
the dip switch 2 on the ADVANCE Control unit. (If gauges are connected the
ADVANCE system, the opening/ending modes for gauges are also changed.)
Change the type when the ignition is off.
Both types consist of digital displays and lighting of sequential indicators. Try
both types!
8 -6. Operation mode
Warning
In order to ensure safe driving, check the information on the gauge only for
a short period of time. Looking at the display for a long period of time could
distract attention from the road and result in an accident.
Do not operate while driving.
8 -6-1.Brightness adjustment
CU OPR
(slide switch position：
U
)
The brightness can be adjusted by pressing
R
button in real
mode and record mode. AUTO and MANUAL can be selected in the setting of
dimmer control in system setup mode.
⇒8 -2-5. Refer to Dimmer setting [DIMMER]
AUTO：3 automatic levels and constant maximum brightness level
(AUTO is not interlocked with vehicle dimmer switch on/off.)
MANUAL： 5 constant levels each in daytime and nighttime being interlocked with ve-
hicle dimmer switch (and one more constant maximum brightness level in nighttime)
Defaults are as follows: MANUAL…ILM. LEVEL5
AUTO…ILM. LEVEL3
The illumination of all the connected gauges is controlled automatically by
using the AUTO dimmer control and by connecting ZD and ADVANCE CR or
ADVANCE BF in the ADVANCE system as following list:
AUTO
MANUAL
ZD OLED
Display
controlled automatically
interlocked with vehicle dimmer
(5 levels each in day & nighttime)
ZD sequential
indicator
changed automatically
(one level each in day & nighttime)
interlocked with vehicle dimmer
(one level each in day & nighttime)
ZD switch
illumination
changed automatically
(light up/light off)
interlocked with vehicle dimmer
(light up/light off)
Switch
illumination of
control unit
changed automatically
(light up/light off)
interlocked with vehicle dimmer
(light up/light off)
ADVANCE CR
illumination
changed automatically
(light up/light off)
interlocked with vehicle dimmer
(light up/light off)
ADVANCE BF
illumination
controlled automatically
interlocked with vehicle dimmer
(5 levels each in day & nighttime)
The illumination level is displayed for 0.5 sec-
ond in multi-display zone (Zone A5) when the
brightness is adjusted.
Bright
Bright
Display
Outside
Dark
Dark
AUTO3
MAX
MANUAL5(D)
MANUAL5(N)
AUTO
MANUAL
AUTO2
AUTO1
81
82