Defi ADVANCE ZD User Manual

Page 20

■ Default display setting
　　　　GAUGE1　　　　　　　　　　GAUGE2

× is displayed on the item zone that sensors are not connected.
■ Zones which the display item can be changed

Zones that the display item can be changed are
A1through A6.

⇒ Refer to 8 -4. Display item change.

8 -6-2-7. TIME ATTACK

Clockings of 0-100km/h and 0-200km/h are available in real mode. While using
MPH setting not km/h, clockings of 0-60MPH and 0-100MPH are available instead.

※ Please read the part of 0-100km/h and 0-200km/h in a different way as

0-60MPH and 0-100MPH if you use MPH setting.

Warning

Do not use the TIME ATTACK function in open roads. It is only for closed courses.

■ Default display setting

× is displayed on the item zone that sensors are
not connected.

■ Zones which the display item can be changed

Zones that the display item can be changed are
A1and A2.

⇒ Refer to 8 -4. Display item change.

REV(Digital)

Water Temp Oil Temp

Speed

Oil Press

Oil Temp

Water

Temp

Clock

Speed

Zone A1

Zone A2

Zone A3

Zone A4

Zone A5

Zone A6

Zone A1

Zone A2

Speed

BEST TIME

TIME

REV(Bar)

Speed

BEST TIME

TIME

■ Time attack setting (Switchover of 0-100km/h and 0-200km/h)

ZD OPR

1. Time attack menu appears by pressing

SET

button.

2. Highlight [SET UP] by pressing

SELECT

button, and then press

SET

button.

3. Highlight [SELECT 0-100 km/h] or

[SELECT 0-200 km/h] by pressing

SET

button.

4. Press

SELECT

button to set.

5. Highlight [RETURN] by pressing

SELECT

button, and then return to the time attack
menu by pressing

SET

button.

6. Highlight [RETURN] by pressing

SELECT

button, and then return to the

time attack display by pressing

SET

button.

■ Measuring time attack

ZD OPR

1. Time attack menu appears by pressing

SET

button.

2. Highlight [START] (by pressing

SELECT

button), and then press

SET

button. [0-100km/h] or [0-200km/h] blinks with 0:00:00 on the

display and ZD is ready to measure. If

SET

button is pressed (mea-

suring is started) while driving, measuring is not started up until the speed
gets to 0 km/h (0MPH) and then speed signal is input again. Buzzer sounds
when measuring starts.

3. Measuring is terminated when the vehicle speed gets to 100km/h under

0-100 km/h setting or 200km/h under 0-200 km/h setting. Best time part
blinks and buzzer sounds when a new record is set. Time part blinks when
a new record is not set.

※ Press

SET

button to cancel measuring while measuring.

※ While measuring 0-200km/h, the best time record for 0-100km/h will be

renewed when a new record of 0-100km/h is set.