Defi ADVANCE ZD - Manual (Page 7)

Power supply voltage 10V ～ 16V DC(For 12V vehicle）
ADVANCE Control
unit Current con-
sumption
+B line 2A（IGN ON）
5mA（IGN OFF）
ILM line 800mA
(Maximum value obtained when connecting 7 gauges and ZDs)
Operation tem-
perature range
-20 ～ +60℃ , -4 ～ +140°F（Under 80％ relative humidity）
Storage tempera-
ture range
-30 ～ +80℃ , -22 ～ +176°F（Under 80％ relative humidity）
Display range Speed 0 ～ 400km/h(0 ～ 240MPH)
Tachometer 0 ～ 11,000rpm
OP1 Oil Pressure 0 ～ 1,000kPa(0 ～ 145PSI)
OP2 Fuel Pressure 0 ～ 600kPa(0 ～ 87PSI)
OP3 Oil Temperature 0 ～ 150℃ (32 ～ 302°F)
OP4 Water Temperature 0 ～ 150℃ (32 ～ 302°F)
OP5 Exhaust temperature 0 ～ 1,100℃ (32 ～ 2,010°F)
Volt 10 ～ 16V
Clock 12 hours display
Applicable speed
pulse 2・4・8・16pulse(mainly for Japanese vehicles)
Pulse free setting: 1,274 ～ 16,562pulse/km,
2,051 ～ 26,665pulse/mile（corresponds to 2 ～ 26pulse)
Applicable number
of cylinders
1･2･3･4･5･6･8 （4cycle）
Dimensions Refer to part names and dimensions section.
Weight 400g, 0.9lb (including box, mounting parts, wires, and accessories）
4 Specification
※ To display OP1 through OP5 in Display range, the sensor sets OP1 through
OP5 need to be purchased separately. (Ex. To display Oil pressure, AD Oil
pressure sensor set OP1 needs to be purchased separately.) However, AD-
VANCE gauges are already installed, the sensor set is not necessary to be
purchased separately.
※ ADVANCE ZD cannot display turbo or intake manifold pressure.
5 Parts list
Blue 4pins
(2lines)
Knob
Components of Brace set
Speed & tachometer
signal wire 2m (6 3/5ft) 1pc
Meter wire 0.5m
(1 3/5ft) 1pc
Double sided tape
1pc
ZD
1pc
Mounting
bracket 1pc
M4 bolt, nut,
washer 1pc
Soderless
connector 2pcs
Tie wrap
2pcs
Clip
2pcs
Brace set
1pc
Brace Bolt holder
Hexagon
head bolt
Accessories
Components are set in brace.
Operation manual (this booklet), and warranty card are included with the parts
listed above.
61 62