Defi ADVANCE Control Unit (DF07703 Manufactured in and before January, 2012) - Manual (Page 13)

5 -2. Part Names & Dimensions of Control Unit in mm(inches)
● Connectors for wires
① Switch unit(white)
② Speed&Tachometer signal wire(blue)
③ Exhaust temp sensor wire(black)
④ Water temp sensor wire(pink)
⑤ Oil temp sensor wire(red)
⑥ Fuel press sensor wire(red)
⑦ Oil press sensor wire(white)
⑧ Turbo/In-Mani sensor wire(light blue)
⑨ Power source wire(beige)
⑩ Meter wire(white) ⑪ Meter wire(white)
Meter wires can be connected to both ⑩ and ⑪ . To protect against short-circuit
between two terminals, the convex connector is inserted into the concave con-
nector ⑪ at the factory prior to shipment. If You don't use ⑪ , do not remove
the convex connector. When using ⑪ , please pull out the convex connector
by pressing the lock, and then connect the meter wire.
153.2(6.03")
DC source(wiring check) LED (blue)
Slots for screw
nut (4 places)
Screw holes(4 places)
104(4.1")
51(2")
26.3(1.04")
22(2.05")
15(0.59")
① ② ③④ ⑤ ⑥ ⑦ ⑧ ⑨ ⑩ ⑪
● Dip switch 1&2
1: Warning buzzer sounds ON/OFF
change
2: Opening・Closing modes
selection(A/B)
Dip switch
51