Bay Technical Associates BayStack ARN Routers none - Manual (Page 88)

Installing and Operating BayStack ARN Routers
3-10 114200 Rev. A
If the LEDs do not light in this sequence, your network administrator can refer to
Configuring Remote Access to help troubleshoot the problem.
If you need additional assistance, contact your local Bay Networks Technical
Response Center.
Powering On and Off the ARN
The ARN power switch is located on the back panel (Figure 3-2) . To power on an
ARN, press the power switch to the ON position (1). To power off the ARN, press
the power switch to the OFF position (0).
Figure 3-2. ARN Power Switch
Note: If the ARN does not contain an expansion module, an adapter module, a
redundant power supply, a data collection module, or a Flash card, the LEDs
associated with these components remain off.
Note: To ensure a complete power cycle, we recommend that you wait at least
4 seconds between powering off the ARN and powering it back on.
ARN0019A
Redundant Power
Console Modem
UL
UL
100-240~
1.2A
50-60Hz
Power switch