Bay Technical Associates BayStack ARN Routers none - Manual (Page 65)

Starting the ARN
114200 Rev. A 2-5
Using EZ-Install
EZ-Install is the default installation option. This option requires that your network
administrator has set up the network so that you can start the EZ-Install procedure.
In addition, this option requires that you
• Install a Flash memory card.
• Connect at least one serial (COM) interface to the network.
Refer to Chapter 1 for instructions on how to perform any of these tasks.
To use EZ-Install:
1. Press the power switch on the ARN back panel to the ON position.
The ARN comes on and activates EZ-Install.
2. Ensure that the ARN boots correctly.
When the ARN boots, its LEDs flash in a particular order. See Chapter 3 for
information on checking the ARN front-panel LEDs to ensure that the
installation was successful and that the router is operating properly.
Note: If your ARN does not have a COM interface, you must configure the
ARN using netboot or directed netboot over an Ethernet, token ring, or
DSU/CSU interface, or local boot the ARN and run the Quick-Start script. Go
to the next section, “Using Netboot, Directed Netboot, or Local Boot,” for
more information.
Note: If you power on the ARN before the network administrator is ready,
restart the ARN by pressing the reset button on the rear panel. See Chapter 3
for more information on resetting the ARN.