Bay Technical Associates BayStack ARN Routers none - Manual (Page 41)

Installing the BayStack Advanced Remote Node
114200 Rev. A 1-11
Connecting to an AUI Interface
To connect an Ethernet AUI transceiver cable to an AUI interface:
1. Connect an Ethernet AUI drop cable to the interface labeled AUI
(
Figure 1-5 ).
The cable must have a 15-position D-SUB receptacle.
Figure 1-5. Connecting an AUI Cable
2. Secure the AUI cable using the slide lock on the interface.
3. Connect the other end of the cable to an Ethernet transceiver.
Caution: Connecting the ARN AUI interface directly to the AUI interface on
an Ethernet station violates IEEE 802.3 standards. The AUI interface is
designed only for connection to a transceiver.
ARN0063A
COM3 COM4 COM5
COM
U
D
DD
B1
B2
RLSD Run
Boot
Diag
Pwr
RPS
Fan
Base
Adapter1
Adapter2
Expansion
DCM
PCMCIA
BayStack Advanced Remote Node
RLSD3
RLSD4
RLSD5
1
2
Serial
Serial
ISDN BRI
withNT1
Tx
Rx
Cl
Tx
Rx
Cl
10BaseT
AUI
Ethernet 1
10BaseT
AUI
Ethernet 2
Expansion module AUI interface
Base module AUI interface
To
Ethernet
transceiver
Ethernet AUI drop cable