Brother FAX-565 - Manual (Page 50)

4 - 6 INITIAL SETUP
Choosing the Handset Volume
(For Volume Amplify)
Before you begin to use your machine, you must decide if you need
to set the handset volume to
VOL AMPLIFY: ON? for a user who is
hearing-impaired. The AMPLIFY volume level complies with FCC
standards.
VOLUME AMPLIFY: OFF
This default setting is appropriate if none of the users are
hearing-impaired. During a conversation, users can press
or
on the control panel to adjust the volume to LOW or HIGH .
When the handset is replaced, the handset volume will remain until
you change it again.
VOLUME AMPLIFY: ON–TEMPORARY
This setting is appropriate if some of the users are hearing-impaired.
During a conversation, users can press
or on the
control panel to adjust the volume to LOW , HIGH or AMPLIFY . When
the handset is replaced, the handset volume returns to the default
setting of
LOW .
VOLUME AMPLIFY:ON–PERMANENT
Choose VOL AMPLIFY: ON? – PERMANENT? if all of the users are
hearing-impaired. During a conversation, users can press or
on the control panel to adjust the volume to LOW , HIGH or
AMPLIFY . When the handset is replaced, the handset volume
returns to the default setting of AMPLIFY .
When you press or on the control panel to adjust
the volume, the LCD shows the setting you are choosing. Each
key press changes the volume to the next setting.
It is important that you do not choose PERMANENT unless all
users are hearing-impaired. Otherwise, the default setting of
AMPLIFY may damage the hearing of some users.