Brother 1270N - Manual (Page 141)

CHAPTER 6 TROUBLESHOOTING
6-19
M-3 Main motor does not rotate
Possible cause Step Check Result Remedy
Failure of
connector 1 Is the connection of connector
P9 on the engine PCB correct? No Reconnect the connector.
Main motor 2 Is the problem solved by
replacing the main motor? Yes Replace the main motor.
Engine PCB 3 Is the problem solved by
replacing the engine PCB? Yes Replace the engine PCB.
Main PCB 4 Is the problem solved by
replacing the main PCB? Yes Replace the main PCB.
M-4 No paper supplied
Possible cause Step Check Result Remedy
Failure of
connector 1 Is the contact of the solenoid
connector on the engine PCB
good? No Reconnect the connector.
Engine PCB
circuit 2 Set paper in the manual paper
slot and make a test print by
pressing the control panel
button. Yes Replace the engine PCB.
Paper pick-up
clutch solenoid Does the voltage between pins
2 (SOLENOID) and 1 (24V) of
the P13 connector on the
engine PCB change from
approx. 24V DC to 0V within
the specified time? No Replace the paper pick-up
solenoid.
Separation pad /
pick-up roller
failure 3 Is the surface of the separation
pad or the pick-up roller dirty or
worn out? Yes 1) Clean the surface of the
separation pad or pick-up
roller.
2) Replace the separation pad
or pick-up roller.
Main PCB 4 Is the problem solved by
replacing the main PCB? Yes Replace the main PCB.