Eu declaration of conformity – Toshiba Satellite A100 (PSAAR) User Manual

Page 4

User’s Manual

TOSHIBA A100

■

Before you connect the computer to a power source, ensure that the

voltage rating of the AC adapter matches that of the available power

source. 115 V/60 Hz in most of North and South America and some Far

Eastern countries such as Taiwan. 100 V/50 Hz in eastern Japan and

100 V/60 Hz in western Japan. 230 V/50 Hz in most of Europe, the

Middle East, and the Far East.

■

If you use an extension cable with your AC adapter, ensure that the total

ampere rating of the products plugged in to the extension cable does

not exceed the ampere rating of the extension cable.

■

To remove power from the computer, turn it off, remove the battery, and

disconnect the AC adapter from the electrical outlet.

■

To help avoid the potential hazard of electric shock, do not connect or

disconnect any cables or perform maintenance or reconfiguration of this

product during an electrical storm.

■

When setting up the computer for work, place it on a level surface.

EU Declaration of Conformity

TOSHIBA declares, that the product: Toshiba A100 conforms to the

following Standards:
This product is labelled with the CE Mark in accordance with the related

European Directives, notably Electromagnetic Compatibility Directive 89/

336/EEC for the notebook and the electronic accessories including the

supplied power adapter, the Radio Equipment and Telecommunications

Terminal Equipment Directive 99/5/EEC in case of implemented

telecommunication accessories and the Low Voltage Directive 73/23/EEC

for the supplied power adapter.
CE Marking is the responsibility of TOSHIBA EUROPE GmbH,

Hammfelddamm 8, 41460 Neuss, Germany, phone +49-(0)-2131-158-01.
For a copy of the related CE Declaration of Conformity please refer to the

following website:

This product and the supplied accessories are designed to observe the

related EMC (Electromagnetic Compatibility) and safety standards.

However, Toshiba cannot guarantee that this product still observes these

EMC standards if accessories or cables not manufactured / distributed by

Toshiba are connected or implemented. To avoid in general EMC problems,

the following advice should be observed:

■

Only CE marked accessories should be connected / implemented

■

Only best shielded cables should be connected

This manual is related to the following products: