Toshiba Satellite A100 (PSAAR) - Manual (Page 131)

User’s Manual 9-16
Troubleshooting
Sleep/Hibernation
LAN
A CONNECT display
is quickly replaced
by NO CARRIER
Check the error control setting in your
communications application.
You can also use the AT\N command. Refer to the
chapter on AT commands in online help files for
Appendix C, AT Commands .
Character display
becomes garbled
during a
communication
In data transmission, make sure the parity bit and
stop bit settings correspond with those of the
remote computer.
Check the flow control and communication
protocol.
You cannot receive
an incoming call
Check the rings before auto answer setting in an
incoming call your communications application.
You can also use the ATS0 command.
If problems persist, contact your dealer.
Problem Procedure
Problem Procedure
The system will not
enter Sleep/
Hibernation
Is Windows Media Player open? The system might
not enter Sleep/Hibernation, if Windows Media
Player is either playing a selection or finished
playing a selection. Close Windows Media Player
before you select Sleep/Hibernation.
If problems persist, contact your dealer.
Problem Procedure
Cannot access LAN Check for a firm cable connection between the
LAN jack and the LAN HUB.
Wake-up on LAN Make sure the AC adaptor is connected. The does
not work Wake-up on LAN function consumes
power even when the system is off.
If problems persist, consult your LAN
administrator.