Toshiba Satellite A100 (PSAAR) - Manual (Page 100)

User’s Manual 7-3
HW Setup and Passwords
2. Enter the currently registered password. The character string you enter
is displayed as a string of asterisks.
Enter Password: ****
3. Click the OK button. If the character string you enter matches the
registered password, the password option is reset and the display
changes to:
Not registered
If they do not match, the following message appears. You must repeat
step 1.
Incorrect Password!!!
4. Follow the same procedures described in the earlier section, How to set
the password, to set a new user password.
Display
This tab lets you customize your computer’s display settings for either the
internal LCD screen or for an external monitor.
Power On Display
Lets you set the display to be used when the computer is booted.
CPU
Dynamic CPU Frequency Mode
This option lets you choose from the following settings:
If you click the OK button before entering the password, Registered
will appear on the display.
If you enter the password incorrectly three times in a row, the computer
need to shut off.
You will not be able to access the password option in the HW Setup. In this
case you must turn the power off and back on to retry the procedure.
Auto-Selected Selects an external monitor if one is connected.
Otherwise, it selects the internal LCD. (Default)
LCD+AnalogRGB Selects both the internal LCD and external monitor
for simultaneous display.
Dynamically
Switchable
CPU power consumption and clock speed
automatic switching function is enabled. When the
computer is in use, CPU operation is automatically
switched when necessary. (Default)
Always Low CPU power consumption and clock speed
automatic switching function is disabled. The CPU
always runs at low power consumption and low
speed.