beautypg.com

Pc cards, Pc cards -2, Installing the pc card -2 – Toshiba Portege 7140 User Manual

Page 108: Installing the pc card

background image

8-2 Optional Devices

User's Manual

Portege 7140CT User's Manual – 7140_UK.doc – ENGLISH – Printed on 20/12/99 as IM_714UK

PC Cards

The computer is equipped with a PC Card expansion slot that can

accommodate two 5 mm Type II cards or one 10.5 mm Type III card. Any

PC Card that meets industry standards (manufactured by Toshiba or other

vendor) can be installed. The slots support 16-bit PC Cards, including

PC Card 16’s multifunction card and CardBus PC Cards.
CardBus supports the new standard of 32-bit PC Cards. The bus provides

superior performance for the greater demands of multimedia

data transmission.

Installing the PC card

Two PC Card connectors are located one above the other on the left side

of the computer. Both connectors are accessed from the same slot. You

can install two Type II cards, one in each connector, or one Type III card in

the bottom connector. Windows allows hot installation of PC Cards, which

means you can install a card while the computer’s power is on.

Check your card’s documentation to see whether it supports hot docking.

If it does not, be sure to shut down the computer in boot mode before

installing the card.

To install the PC Card, follow the steps below.

1.

A dummy card is installed in the computer when it is shipped. To eject

the dummy, slide the left eject latch to the right. Store the dummy card

in a safe place for use, if you remove the PC Card.

Removing the dummy card

This manual is related to the following products: