Pioneer AVIC-X1BT - Manual (Page 96)

94
Chapter
7
Using the
AV Source (Pionee
r
AV E
q
uipment)
AV
TV Tuner
• For safety reasons, video images cannot
be viewed while your vehicle is in motion.
To view video images, you must stop in a
safe place and put on the handbrake
before setting your route (see page 10
Interlock for details).
Watching the TV tuner
You can use the navigation system to control a TV
tuner, which is sold separately.
For details concerning operation, refer to the TV
tuner’s operation manual. This section provides
information on TV operations with the navigation
system that differ from those described in the TV
tuner’s operation manual.
When you attempt to watch video images while
driving, the warning VIDEO VIEWING IS NOT
AVAILABLE WHILE DRIVING will appear on
the screen.
❒ Pressing the DISP button changes the
screen display.
➲ Switching screen display ➞ Page 111
(1) Source icon
Shows which source has been selected.
(2) Band indicator
Shows which band the TV tuner is tuned to.
(3) Preset number indicator
Shows which preset has been selected.
(4) Channel indicator
Shows which channel the TV tuner is tuned.
(5) Preset list display
Shows the preset list.
1
Touch the source icon and then touch
“TV” to select the TV.
2
Touch the screen to display the touch
panel keys.
3
Touch “BAND” to select a band.
Touch “BAND” repeatedly until the desired
band is displayed, TV1 or TV2.
4
To perform manual tuning, touch  or 
briefly.
The channels move up or down step by step.
You can also perform manual tuning by mov-
ing the joystick left or right.
5
To perform seek tuning, keep touching 
or  for about one second and release.
The tuner will scan the channels until a broad-
cast strong enough for good reception is
found.
You can cancel seek tuning by touching either
 or  briefly.
If you keep touching  or  you can skip
broadcasting channels. Seek tuning starts as
soon as you release the keys.
You can also perform seek tuning by holding
the joystick left or right.
Storing and recalling broadcast
stations
If you touch any of the preset tuning keys P1—
P12 you can easily store up to 12 broadcast sta-
tions for later recall with the touch of a key.
1
When you find a station that you want to
store in memory keep touching a preset
tuning key P1 — P12 until the preset
number (e.g., P.ch: 1) stops flashing.
The number you have touched will flash in the
preset number indicator and then remain lit.
The selected station has been stored in mem-
ory.
The next time you touch the same preset tun-
ing key P1 — P12 the station is recalled from
memory.
To switch between P1 — P6 and P7 — P12,
touch
or .
When the touch panel keys are not displayed,
you can display them by touching the screen.
(2) (1) (4)
(5)
(3)
TV