Pioneer AVIC-X1BT - Manual (Page 58)

56
Chapte
r
5
Customis
ing Y
our N
aviga
ti
o
n
S
ystem
NAV
I
Guidance Volume
Touch “+” or “–” to change the Guidance volume.
Beep Volume
Touch “+” or “–” to change the Beep volume.
❒ Volume of the audio source is adjusted by the
VOLUME /ATT button of the navigation sys-
tem.
Mute Settings
Items related to muting of sound volume can be
set.
❒ When Voice Guidance or Voice Recogni-
tion are “On”, be sure to set the TEL/GUIDE
setting in the Audio Menu to MUTE or ATT.
➲ Switching the muting/attenuation ➞ Page 108
• Voice Recognition
This setting controls whether the volume of the
Audio source is automatically muted during voice
operation.
On* :
During voice operation, the volume of the Audio
source is muted automatically.
Off :
The volume of the Audio source stays the same
during voice operation.
❒ If you select “Off”, the sound from the Audio
source may interfere with the voice recogni-
tion system.
• Voice Guidance
This setting controls whether the volume of the
Audio source is automatically muted during voice
guidance.
On* :
During voice guidance, the volume of the Audio
source is muted automatically.
Off :
Volume of the Audio source stays the same dur-
ing voice guidance.
System Options
Touch “System Options” in the Setting Menu to
display.
Language Selection
➲ The language displayed can be set ➞
Page 121
Once you change the language, installation of
the programme starts.
• Once the installation of the programme
starts, do not stop the engine of your vehi-
cle and do not switch off the navigation
system until the installation is completed
and the map of your surroundings appears.
KM Mile Setting
This setting controls the unit of distance dis-
played on your navigation system.
km * :
Show distances in kilometres.
Mile :
Show distances in miles.
Mile & Yard :
Show distances in miles and yards.
Voice Recog.Help
This setting controls the list of available voice
commands displayed during voice operation.
You should set “Voice Recog.Help” only when
the microphone of the voice recognition system
(sold separately) is connected.
On* :
The list of commands is shown.
Off :
The list of commands is not shown.
Auto Voice Recognition
After you have started the engine, turn on voice
recognition and set whether or not to perform all
operations up to route searching by voice.
(This function is effective only when a route is not
set.)
❒ You should set “Auto Voice Recognition”
only when the microphone of the voice recog-
nition system (sold separately) is connected.