Pioneer AVIC-X1BT - Manual (Page 60)

58
Chapte
r
5
Customis
ing Y
our N
aviga
ti
o
n
S
ystem
NAV
I
Map Display Options
Touch “Map Display Options” in the Setting
Menu to display.
Tracking Display
The tracking display setting has the following
options.
Always :
Display tracking for all journeys.
This Trip :
Display tracking dots but erase them when the
navigation system is turned off (when turning off
the engine of your vehicle).
Off* :
Do not display tracking dots.
AV Guide Mode
Sets whether to switch to the navigation screen
automatically when your vehicle approaches a
guidance point, such as an intersection, while
displaying a screen other than navigation.
On* :
Switches from audio operation screen to naviga-
tion screen.
Off :
Screen is not switched.
Day/Night Display
To improve the visibility of the map during the
evening, you can change the combination of the
colours of the map.
Illuminated* :
You can change the combination of the colours
of a map according to whether the vehicle lights
are On or Off.
Daytime :
The map is always displayed with bright colours.
Close-up of Junction
This setting enables to switch to an enlarged map
around the point where your vehicle is approach-
ing an intersection, entrance/exit of motorway, or
a junction.
On* :
Display switches to an enlarged map.
Off :
Does not switch to an enlarged map.
Arrow in AV
Set whether to display the guidance information
with arrows on the Audio Operation screen.
On* :
Display guidance information with arrows on the
Audio Operation screen.
Off :
Do not display guidance information with arrows
on the Audio Operation screen.
Defined Locations
Touch “Defined Locations” in the Setting Menu
to display.
Set “Home”
➲ Registering and changing your home location
➞ Page 43
Map In Memory
The memory area is the area in the map, which is
being read in advance for the memory navi mode.
There are two ways of setting the memory area.
Around Current Position
A square that has sides of approximately 17 km
(10.6 miles) with the selected location at the cen-
tre is read into the memory.
Indicate the map you want to store in the memory
by touching , ,  or . Then, adjust the map
scale to the one you desire, and touch “OK”.
Continuously touching , ,  or  allows you
to rapidly scroll the map screen.