Pioneer AVIC-X1BT - Manual (Page 56)

54
Chapter
4
E
d
it
in
g the Na
vigation Utilit
ie
s
NAV
I
(5) Speed
Speed detected by the navigation system is
indicated. (This indication may be different
from the actual speed of your vehicle, so
please do not use this instead of the speedom-
eter of your vehicle.)
(6) Acceleration or deceleration/Rota-
tional speed
Acceleration or deceleration velocity of your
vehicle is indicated. Also, rotational speed
when your vehicle turns to left or right is
shown.
(7) Inclination
Degree of slope of the street is indicated.
To clear values...
If you want to delete the learned results stored in
“Distance”, “Speed Pulse” or “Learning Sta-
tus”, touch the relevant result, then touch
“Clear”.
❒ The navigation system can automatically use
its sensor memory based on the outer dimen-
sions of the tyres.
Checking the connections of
leads and installation positions
Check that leads are properly connected between
the navigation system and the vehicle. Please
also check whether they are connected in the
correct positions.
1
Touch “Settings” in the Main menu, then
touch “Hardware Info”.
2
Touch “Connection Status”.
The Connection Status screen appears.
(1) Speed Pulse
The Speed Pulse value detected by the naviga-
tion system is shown. “0” is shown while the
vehicle is stationary.
(2) GPS Aerial
Indicates the connection status of the GPS
aerial, the reception sensitivity, and from how
many satellites the signal is received.
If the signal is received correctly, “OK” is dis-
played. If reception is poor, “NOK” appears.
(3) Installation Position
The Installation position of the navigation sys-
tem is shown.
If installed correctly, “OK” appears. Indicates
whether the Installation position of the naviga-
tion system is correct or not. When the navi-
gation system is installed at an extreme angle
exceeding the limitation of the installing
angle, “Incorrect angle” will be displayed.
When the angle of the navigation system has
been changed, “Excessive vibration” will be
displayed.
(4) Hand brake
When the handbrake is applied, “On” is dis-
played. When the handbrake is released, “Off”
is displayed.
(5) Power Voltage
The power supply (reference value) provided
from the vehicle battery to the navigation sys-
tem is shown. If the voltage does not fall
within the range of 11 to 15V, check that
power cable connection is correct.
(6) Illumination
When the headlights or small lamps of a vehi-
cle are on, “On” is displayed. (If the orange/
white lead is not connected, “Off” appears.)
(7) Back Signal
When the gearstick is shifted to “R”, the signal
switches to “High” or “Low”. (Which of these
is displayed depends on the vehicle.)
(1)
(2)
(3)
(4)
(5)
(6)
(7)