Pioneer AVIC-X1BT - Manual (Page 112)

110
Chapter
8
Customi
sing
the Audio Source Setting
AV
❒ Rear View can be displayed at all times (e.g.
when monitoring an attached trailer, etc.) as a
split screen where map information is partially
displayed. Please be aware that in this setting,
camera image is not resized to fit, but that a
portion of what is seen by the camera is not
viewable.
❒ Initially, this function is set to OFF.
1
Touch “CAMERA” in the SETUP menu.
2
Touch “CAMERA” to turn rear view cam-
era setting on.
Touching “CAMERA” switches between
“ON” and “OFF”.
❒ Unless this setting is “ON”, you cannot
switch to Rear View mode.
3
Touch “POLARITY” to select an appropri-
ate setting for polarity.
Each time you touch “POLARITY” switches
between the following polarity:
• BATTERY — When the polarity of the con-
nected lead is positive while the gearstick is
in the REVERSE (R) position
• GND — When the polarity of the connected
lead is negative while the gearstick is in the
REVERSE (R) position
Selecting the video of rear dis-
play
When the navigation screen is displayed on front,
you can select to show either the navigation
screen or the selected source on the rear display.
❒ The map screen navigation images output to
the rear display differ from standard NTSC for-
mat images. Therefore, their quality will be
inferior to the images that appear on the front
display.
1
Touch “REAR DISP” in the SETUP menu.
Each touch of the “REAR DISP” changes the
settings as follows:
• SOURCE — Display the video of the
selected source on rear display
• NAVI — Display the navigation video on
rear display when the navigation screen is
displayed on front
❒ When selecting “SOURCE” in “REAR
DISP”, when the selected source is an
audio source, nothing is displayed on rear
display.
❒ When selecting “SOURCE” in “REAR
DISP”, nothing is displayed on rear dis-
play during a traffic announcement inter-
ruption or a news programme interruption.
❒ When selecting Rear View in the map dis-
play, nothing is displayed on the rear dis-
play.
Setting the slide back function
You can adjust the LCD panel slide position to
prevent the display from hitting the gearstick of
an automatic vehicle when it is in P (park) posi-
tion.
❒ Please be careful, as the LCD panel will slide
immediately after the setting is turned “ON”.
1
Touch “FLAP SET BACK” in the SETUP
menu.
Touching “FLAP SET BACK” switches
between “ON” and “OFF”.
Setting the automatic open
function
When you do not wish the display to open/close
automatically, you can set the automatic open
function to the manual mode.
1
Touch “AUTO FLAP” in the SETUP
menu.
Each touch of the “AUTO FLAP” changes
the settings as follows:
• MANUAL — You have to press the OPEN/
CLOSE button to open/close the display
• AUTO — The display automatically opens/
closes when power to navigation system is
turned on
O
ther Functions