Konica Minolta bizhub C451 - Manual (Page 319)

Network Settings 4
C451 4-74
4.9 E-Mail TX (SMTP)
Information, such as the SMTP server, that is required to send data as an e-
mail attachment in Scan mode can be specified. In addition, authentication
settings can be specified for e-mail transmission. Settings can be specified
for the following.
!
Detail
For sending e-mail, administrator address must be specified on this ma-
chine. For details on the administrator address setting, refer to the User’s
Guide [Copy Operations].
E-Mail TX (SMTP) screen 1/5
E-Mail TX (SMTP) screen 2/5
E-Mail TX (SMTP) screen 3/5
2
Note
It may not be possible to read the e-mail messages if the e-mail software
used to receive e-mail is not equipped with a restoring function.
Parameter Description
Scanning Select whether or not Scan to E-Mail operations are used.
Status Notification Select whether or not status notification is used.
Total Counter Notification Select whether or not total counter notification is used.
Parameter Description
SMTP Server Address Specify the address of the SMTP server used to send e-mail mes-
sages. For details, refer to “SMTP Server Address” on page 4-79.
Parameter Description
Binary Division Specify whether or not a large e-mail message is divided and sent
in small sections. This is used to send data that has exceeded the
maximum capacity when the maximum capacity is limited per e-
mail message on the e-mail server.
Divided Mail Size Specify the size of divided data when dividing the data to be sent.
To change the setting, press the [C] (clear) key, and then use the
keypad to type in the desired setting. (Range: 100 to 15000 KB)