Continuous feed, 12 feeding documents manually, Open the hopper if it is closed – Konica Minolta Fujitsu Scanner User Manual
Page 58
38
2.12 Feeding Documents Manually
■ Continuous Feed
1.
Open the hopper if it is closed.
“2.2 Opening and Closing the Hopper” on page 10.
2.
Press down the Hopper Height Button ( ) on the Operator Panel for more
than 3 seconds.
⇒ Hopper will move up to the manual feed position.
3.
Place documents face-up at the center of the hopper table.
At this moment, do not stick the top edge of the document against the inner side of the hopper,
instead set them a bit apart.
4.
Start the application and display the scanner driver screen.
Set the scanning condition.
For the information about how to run the scanner driver, refer to
ATTENTION
• Be careful not to get your fingers or anything caught in the mechanism
when the hopper table moves up.
• To deactivate the “Manual Feed Mode” (Continuous Feed) in the middle
of an operation, press down the Hopper Height Button ( ) on the Oper-
ator Panel for more than 3 seconds.
Send
to
Sca
n
Power T
hickness
Hopper H
eig
ht
Function
Thick
Thin
Function
Hopper Height
Paper Thickness
Thin
Send to
Scan
Thick