Konica Minolta Fujitsu Scanner - Manual (Page 206)

186
8.10 Paper Jam Detection
8.10 Paper Jam Detection
You can set the degree of detection sensitivity for a jam at the feeder.
Configure the settings for Paper Jam Detection as follows:
1. Start up the Software Operation Panel.
Refer to “8.1 Scanner Settings” on page 166 .
2. Select the “Paper jam detection” setting on the [Device Setting 2] tab.
3. Set the degree of detection sensitivity for a jam occurred at the feeder.
If you encounter frequent jams, set the setting to “Sensitivity-Low”.
ATTENTION
Setting to “Sensitivity-Low” reduces the detection accuracy for a paper
jam.
If you don’t want to get your important document ripped or crumpled, be
sure to set the setting to “Normal” to scan the document.