Specifying the lpr settings, Specifying the lpr settings -14 – Konica Minolta bizhub C200 User Manual
Page 70
C200
5-14
Installation on Macintosh computers
5
–
If a different PPD file has already been selected, click the [Setup] button in step 3, and then click the
[Select PPD] button from the window that is already displayed.
A window for specifying options appears.
5
Select options installed on this machine on the "Options Installed 1" and "Options Installed 2" windows.
6
Click the [OK] button.
The "selector" window appears again.
7
Close the "selector" window.
Specifying the LPR settings
Specifying the IP address setting for this machine
Specify the IP address of this machine.
!
Detail
For details on specifying the IP address of this machine, refer to the User’s Guide [Network
Administrator].
LPD setting for this machine
To use LPR printing, enable the LPD setting with the software switch (mode 384) of this machine.
!
Detail
For details on the LPD settings of this machine, refer to the User’s Guide [Network Administrator].
Specifying the TCP/IP setting for the computer
Specify the TCP/IP setting for the Macintosh computer connected to this machine.
1
On the "Apple" menu, select "Control Panel" - "TCP/IP".
2
From the "Connect via" drop-down list, select "Ethernet".
3
Select "Configure" items according to the settings for the network to which the Macintosh computer is
connected, and then specify the IP address and subnet mask.